A new set of fenders purchased back in 2009 and never used came to mind.

They haven't been out in the light for many years.

They needed holes drilled for tail lights and wiring. After drilling and some sanding they got some new primer.

And then the Persian Orange.

I mounted the lights and pulled the wires through the channel before I mounted the fenders.

Only front and rear attachment bolts get large reinforcing washers, later series had them on all three. I'll add the other one if I find a couple.

The tail lights are very red and bright with red LED tail light bulbs.

The toolbox really needed some attention to be mounted on the newly painted fender. A bit of straightening and JB Weld to fill rust holes in the bottom.